VERSION 3.0 IS PUBLISHED ON MY PROFILE - IT IS MUCH BETTER!

This is version 2.0 of my Mini Screwdrivers

I've added the bit symbol to the case, so you don’t have to open it up to see which bit is inside. I have included Flathead, Phillips, Robertson, and Torx. (will add more by request)

I've tweaked the fit of the bit (still snug, but not quite as snug. It’s meant to be semi-permanent. You might need a pliers to remove the bit, however I was able to remove mine by hand).

I put the keychain hole in the cap, instead of the body, where it belongs. I also added a cap version with no hole.

Print settings:

• Layer Height: 0.1 (I have not tested any other layer height)
• Number of walls: 3+
• infill: gyroid 15-20%

Threads will be tight at first, but will loosen up after screwing in and out a dozen times.