Bathroom/kitchen organizer:
- soap/sponge/rubber duck holder with drip chute
- toothbrush/razor/brush/toothpaste holder
- space for shampoo/dishwasher
- …

The prototype was printed in PLA: ~110g filament, ~4+h print time, minimal amount of support

+ 4 TPU legs to prevent slip and give some clearance so water can drip out at the bottom

+ a bottom tray if needed (this does not cover the soap holder's drip chute, that should stick out over the sink)

For future easy clean I will print the final model in ABS and use acetone vapor smoothing.

The soap tray is at 33°, consider printer capabilities if choosing not to add support - X1C can handle it without support.

Dimension without tray: width: 174mm * depth 104mm base + ~23mm chute * height 102,2mm + 3mm legs
Tray: 186.5mm * 116.5mm