I hate using normal scrapers because they scratch the 3D printer bed, and plastic scrapers are not strong enough, so I made this scraper so the tip of the blade never touches the bed, but it gets very close to be effective removing the plastic attached.

You need:

• Bambu Lab blade.

• M3x20mm screws with washers.

• Lock nuts.

• I also made an optional holder that uses 7x5mm magnets.

My original design had a fixed height/angle but I discovered that it's better to be able to change the angle to accommodate differences on blades and even wear so I have available both version.

The assembly is really easy with washers at the ends and the lock nut keeping the screws with a slight pressure. The hard part is adjusting the height of the blade to keep it at a perfect angle and level.

The design is very compact so it can be manipulated inside small spaces like inside the printer.