Designed to print with a 0.4mm nozzle, 0.2mm layer height in VASE mode. 

Very plastic efficient as the base takes less than an hour to print with approximately 7.2g of filament used and the lid takes about 30 minutes to print with approximately 4.8g of filament used.

PLA is a recommended filament but I am sure others would work also.

The top and bottom embosses engage to provide positive “locking” engagement between the two parts so the lid doesn't just slide off if you are using this as a Halloween party favour filled with some treats (or tricks :)

The .3mf files have the associated slicing information and orientation.  I have also included the step files should you wish to quickly modify/remove the text or may any other tweaks, remixes or adjustments.