The case consists of two pieces (upper & lower). Every upper part of the case is compatible with every lower part. Just print what fits your application the best :-)

Upper part:

Covers the top of the Pico where the Raspberry logo and the onboard LED are located. There are two variants: With “Pico” text and without.

Lower part:

Holds the Pico Board firmly into the upper part. There are three variants: 

• Lower case: Covers the pins but they are still accessible. Additional openings allow to still see the pinout labeling on the board.
• Lower case closed: Covers everything.
• Lower case minimal: Just a tiny frame that fixes the board in place and makes everything very easy to access.

I added .3mf files of the closed and no text variants so you can get creative with your own case!

Screws:

You need four M2 screws to connect both parts of the case.

Max. length: 12mm

Min. length: 8 mm (best for “minimal” case variant) 

Print instructions:

0.2 mm layer height, no supports.

I would be very happy if you would share your experience with the case and photos of the printed results in the comments! :-)

This is my private creation allowed only for non-commercial use.