Items you need:

• 2 x “4mm x 30cm” paracord.
• *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).
• *2 x “12mm” wiggly eyes.
• Super glue (for the eyes, mouth and magnets).

*If you do not have wiggly eyes and magnets, I have included a 3D printed option - Eyes (black and white part) & a Connector.

Suggested print settings for the Main Body:

• Layer height 0.2mm.
• Infill 30%.
• Position the print in a way that the joining face is facing downwards.
• No supports are needed.

Suggested print settings for Mouth:

• Layer height 0.2mm.
• Infill 15%.
• Brim: Width 2mm.
• Brim Separation Gap: 0.2mm.
• Position the print in a way that the chamfered side is facing upwards.
• No supports are needed.

Affix the mouth to the main body with the chamfered side facing downwards.

For more interesting zipper pull charms, be sure to track this tag (Zipperrific).

We've even conjured up a little home for our zipper pulls – because they deserve a stylish rest when they're not out and about with you! And to top it off, each zipper pull features a sneaky slit perfect for showcasing photos, name cards, and more. They're not just zipper pulls; they're your new tiny, table-top pals! 🌟

NOTE
Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.