[https://www.thingiverse.com/thing:5715066](https://www.thingiverse.com/thing:5715066)

Summary

I designed this thing so you can easily wall mount the controller for the Mixergy Smart Hot Water tank.

The Mixery tank comes shipped with an (adhesive) magnetic mount system, which limits where to mount it (e.g. a smooth surface).
This 3d printed holder allows the controller to be mounted to a wall made of any material, such as plaster, block, wood, stone etc.

Note: the magnetic strip on the back of the controller does not need to be removed when used with this holder, as I have allowed a recess for it to sit in.

Install

• mount the holder to the wall (2 screw holes provided)
• unplug and disconnect the controller from the Mixergy tank
• feed the controller plug and cable through the hole in the holder
• slide the controller into the holder
• reconnect / plug back in the controller to the Mixergy tank

Design Features

• 2x screw holes (designed for 4mm dia screws)
• recess to accommodate magnetic adhesive strip on reverse of controller
• channel cutout on the rear to allow cable tie / elastic band for extra support at top of controller (optional)

Mixergy

Mixergy is a UK company founded in Oxford that designs and sells smart Domestic Hot Water cylinders - [https://www.mixergy.co.uk/](https://www.mixergy.co.uk/)

Print Settings

• Rafts:

No

• Supports:

Yes

• Resolution:

0.28mm

• Filament brand:

Generic

• Filament material:

PLA

• Notes:

I used 0.28mm layers as this is mounted out of sight and doesn't need detail.
I used tree supports, but any should do.
Took just under an hour to print with my settings.