A human sized Sauron's Mace, not much else to say here!

In the middle of the parts there is a hole with a diameter of 16mm, it's for a wooden (or any kind of material) stick, that way the mace won't be flimsy when you glue it together.
There are also two 5mm holes for two metal sticks, you can skip this probably but I recommend putting any kind of sticks in, to securely keep the mace parts from rotating after you glue them together (I myself decided to just print a couple of long 4.5mm diameter sticks and put them into the holes to make sure all the parts are aligned)

You must print:
2x"blade with hole 1"
2x"blade with hole2"
4x"blade 1"
4x"blade 2"
1x “pole ring”
1x “ending 1”
1x “ending 2"
1x “top mace 1”
1x “top mace 2"
1x “top mace 3”
1x “pole 1”
1x “pole 2”
1x “handle bot”
1x “handle mid”
1x “handle top”

You don't need any supports!

DISCLAIMER: This model has not been yet printed by me, so even though I tried making the model as printable as possible, you might encounter issues, but the chances are low.
As you can see, “Au Bon Stuff” has printed the mace and posted a make, make sure to check it out! Though if you print the model and there are issues then contact me please! 
Also please post a make once you're done :)

CREDITS: Initial model was made by “VertexDon”, I based the whole model on it and made it printable. 

29.12.2023 Edit: I finally printed my own Sauron's Mace and did notice a couple of issues when assembling so I did some QOL updates to the “blades” of the mace - the improved files are marked as “V2” and the old ones are located in the “outdated” folder if you need them for whatever reason!