A slightly raised, 10° angled eye-pleasing speaker stand for your desk. 

Originally created for the classic Edifier R1280T/DB, this speaker stand will most likely fit any speaker with a minimum length and width of 160 x 120 mm (6.3 x 4.72 in).

If you're using the Edifier R1280T/DB, the speaker stand works with both, the rubber feets attached or removed. If the rubber feets are removed, the speaker will fit right onto the stand. 

Minimum print bed size: 170 x 130 x 50 mm 
Easy and quick to print, no support necessary, simple assembly.

Despite the addition of some tolerance, inserting the wedge may require a bit persuasion. 

What if I need a different angle?

Since not all desks and setups are the same, I also attached a 5° and 15° angled version.