Doesn't require cutting or glueing for secure fit. Just remove crusty old rubber strips and snap on this instead!

This part is designed to be printed in TPU. Printed mine in 95A TPU, should probably work fine for softer material as well.

You'll need to print the part twice. I recommend printing them one at a time to minimize stringing.

My scroll wheel had a plastic bump under the rubber on one side. In case you've got one as well it's easy to remove with an x-acto knife.

Recommended layer height is 0.12mm (including first layer).

This part is a bit taller than the original so it can be printed with 4 walls to minimize travel and retraction. It feels great too!