Push block for woodworking. 

For security while using router table, table saw, jointer, etc...

Handle and base printed in PLA. Handle screwed to base (I used drywall screws and screwed them in slowly) / bottom grips printed in TPU and glued to the base.

Designed to allow very thin cuts on my table saw without putting my fingers in danger. You can reverse and use the handle either way so you can cut different distances from the fence. I have been using it for a little over a year and it works great!

Quick note; Handle was taken from many designers on Thingiverse using the same handle and therefore I do not know who the original designer is and can not give attribution but the base and grips are designed by me.