Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
A perfect model to test your printers ability to properly retract filament, and test its bridging capabilities. This is done with two small towers either side causing the printer to have to travel across the middle on each layer. If the printer is incorrectly calibrated it will cause stringing filament across the middle. The bridging test is simply a bridge across the top of the towers. This tests printer settings, part cooling, and print temperature. If this is not all correct the bridge may droop down.
Printer Settings:
Layer Height - 0.2mm or 200 microns
Infill - 0%
Stringing & Bridging Test
Publicado el 10 de sep. de 2023
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta