For The Basic version you need 12x Rod, 2x Base and 1x Midplate

Print the Base and Midplate first, then print one rod to test fitment.

For each additional floor you need 6x Rod and 1x Midplate.

It seems a bit wobbly at first, but the plant will hold it in place perfectly.

If not… glue it down.

The current model is for a pot with outer diameter 160mm.

You can open the parametric Fusen360 file and change the “pot_outer_dia” and “gap_for_pot_edge” parameter to your needings.

The first extrusion is for the height of the flange of the base, where the pot edge goes in.

Standart is 3mm

You can put the diameter you need in the comments if you don't have Fusion360 and I will upload it.