Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Originally published here: One Ring by tato_713 - Thingiverse
This model was based on this image, using MATLAB R2016a to make the "height map" of the inscription on a toroid instead of a sphere, unlike most of the models I've made by this way. I tried to follow the proportions of the ring from the Lord of the Rings (LotR) and The Hobbit films. The files have different inner diameter, from 9 to 24 mm. All of them are the same file scaled to fit to the inner diameter. It is also included a 9cm diameter ring if you want to use it as a bracelet.
Check out this amazing pure gold casting of this model, made by AlumiTube:
I spend part of my time making these models, letting them available and free for everyone. If you want to support my work you can buy me a coffee in Ko-fi:
Si estás en Argentina podés invitarme a un cafecito:
Update: all the models were changed following standard sizes from here. You can check this to find the equivalent for the different size conventions. I will left the links in a list here for the files with their inner diameter to simplify:
- Bracelet
- 9.91mm
- 10.72mm
- 11.53mm
- 11.95mm
- 12.18mm
- 12.37mm
- 12.60mm
- 12.78mm
- 13.00mm
- 13.21mm
- 13.41mm
- 13.61mm
- 13.83mm
- 14.05mm
- 14.15mm
- 14.25mm
- 14.36mm
- 14.45mm
- 14.56mm
- 14.65mm
- 14.86mm
- 15.04mm
- 15.27mm
- 15.40mm
- 15.53mm
- 15.70mm
- 15.80mm
- 15.90mm
- 16.00mm
- 16.10mm
- 16.30mm
- 16.41mm
- 16.51mm
- 16.71mm
- 16.92mm
- 17.13mm
- 17.35mm
- 17.45mm
- 17.75mm
- 17.97mm
- 18.19mm
- 18.35mm
- 18.53mm
- 18.61mm
- 18.69mm
- 18.80mm
- 18.89mm
- 19.10mm
- 19.22mm
- 19.31mm
- 19.41mm
- 19.51mm
- 19.62mm
- 19.84mm
- 20.02mm
- 20.20mm
- 20.32mm
- 20.44mm
- 20.68mm
- 20.76mm
- 20.85mm
- 20.94mm
- 21.08mm
- 21.18mm
- 21.24mm
- 21.30mm
- 21.49mm
- 21.69mm
- 21.89mm
- 22.10mm
- 22.33mm
- 22.60mm
- 22.69mm
- 22.92mm
- 23.06mm
- 23.24mm
- 23.47mm
- 23.55mm
- 23.87mm
- 24.27mm
Print Settings
Resolution:
0.1 or lower
Infill:
Doesn't matter
Notes:
It is recommended to use brim or raft because of its small contact surface with the bed. The details of the inscription are to small for the usual 0.3mm resolution, it is recommended to print it with the resolution as low as possible.
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta