TPU case for Oneplus 3/3T. The model works great, but there is always room for improvements. So feel free to optimise the case.

I do have a phone mounting system glued to the rear of the device. Thats why there are two versions of the files. One has a large cutout on the back, tho other one doesn´t. The gcode has the cutout on the back. So please slice yourself, if you don´t need it.

Print instructions

The model was printed in NinjaFlex TPU. I used most of the print settings from Mre´s NinjaFlex profile. You can check it out here:
[https://www.prusaprinters.org/prints/12586-ninjaflex-profile-zero-stringing-flawless-print-be](https://www.prusaprinters.org/prints/12586-ninjaflex-profile-zero-stringing-flawless-print-be)

I had to remove a lot of support structures with a cutter knife, so don´t expect too much of the optical Quality, when printing with TPU.