A stand for a Raspberry Pi Zero and HAT (or pHAT) with a hinged base allowing for an adjustable display angle. There are two versions; one with a cutout for the power socket only, and another with cutouts for the HDMI and USB sockets. 2 x M3 20-30mm screws are required for the hinged base, and M2.5 can optionally be used to hold your HAT in place (although I found these weren't needed, and the case was snug enough around the HAT header to hold everything in place). Once your Pi is in, the back snaps into place.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Category: Electronics