Print guide

1. In the slicer, the hook should be laying on its side like the photo below
2. Use the highest layer height setting available to print it faster (I used 0.4mm)
3. Brims, supports, or any other special settings are not necessary

Optional: Make it more secure

To stabilize the hook, attach grip pads onto the inner side of the hook. I used Setex gripping pads 0.5" circles (link)

Designer notes:

For this hook, I wanted to design something that's sturdy enough for small items, easy to mass-produce, and fits the minimal aesthetic of the LACK table. Hope it serves you well :)