Stackable Organizer System

This is a little system of different sized containers. The design goals are the following:

Look nice so it can be left out visible on the desk, dressing table or bath room. No obvious 3D-printed vibes.
Form over space optimization.
Easy and fast to print but still sturdy enough.

The system is rectangular/square but with very chamfered and rounded corners, walls gently tapered. There are 3 different side lengths (80mm, 100mm and 180mm) and 5 different heights (36mm, 50mm, 84mm, 132mm and 180mm). Every variation of these dimensions are available for download as an STL file.

There are also two lid options:

Slick lid: Sits very neat and flat on top of container. Finger hole for easy opening, lid just rests in place.
Stackable lid: Similar but with a slightly raised edge so that other containers or objects can be stored on top without sliding off. Containers within their own base size can be stacked without lid.

Other notes:

Those models I frequently print and use are marked as my favorite in the file comment. I don't have that much experience with the taller versions like 132mm and 180mm.
I print these as fast as I can at 0.3mm layer height. A “galaxy” type or similar layer line hiding filament is recommended.
All STL models are already in the recommended print orientation.
The 50mm height is special in that when stacked with another size, the sum equals the next larger size. For example: H36 + H50 = H84 (when stacked without lid).

Descrição