Introduction

This is a simple cable spool I created as the ones I could find didn't satisfy my needs, either too large or too small, so I made this one, it can hold 10-20m of cable maybe more.

Disclaimer: I've only tested the default Ø110mm with 30mm width using STEP files.

Planned

Multiple side diameters.

Update

V3 now includes the hole for the cable beginning at the side of the spool core.

Theres now a few more options for core widths.
 

Printing

It can be printed as is but for the core I'd recommend supporting the lower edge and adding some brim since it can end up getting loose 4 minutes before its done printing after over an hour resulting in one side not working.

Assembly

To assemble the cable spool it's a simple matter of just screwing the sides onto the core with the threads on the parts.