Simple remix that changes from standard pegboard to Wall Control dual slot. This uses 2 slots with a strengthened design compared to the normal Wall Control Hook shape.

I have added a 2 versions to support normal and and slightly larger cans. 

I am using my Wall Control bases from here: 

[https://www.printables.com/model/53629-wall-control-hooks](https://www.printables.com/model/53629-wall-control-hooks)

Print instructions

Unfortunately the can design requires it to be printed vertically in the normal upside-up (vs upside down) or sideways orientation.  Once I need to make new can holders, I will modify the design for upside down which will be a bit easier for cleaning up supports on the mounting brackets. 

Filament:
Prusament PETG Orange . Use PETG or stronger material. PLA is NOT RECOMMENDED as it is too weak and will break under load after some time.