Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
A Wall Control slot version of the Pegboard Tape Holder by @rordaz. This supports the Wall Control slot + peg system. Each side uses dual slots for increased stability. I use my dual slot base from here: [https://www.thingiverse.com/thing:4097266](https://www.thingiverse.com/thing:4097266) and combine it in Tinkercad.
Print instructions
Category: Organization Summary
A Wall Control slot version of the Pegboard Tape Holder by @rordaz. This supports the Wall Control slot + peg system. Each side uses dual slots for increased stability. I use my dual slot base from here: [https://www.thingiverse.com/thing:4097266](https://www.thingiverse.com/thing:4097266) and combine it in Tinkercad.
Print Settings
Printer Brand:
FlashForge
Printer:
Creator Pro
</div>Rafts:No
Supports:
Yes
</div>Resolution:.3mm
Infill:
30%
</div>Filament:
Prusament PETG Orange
Notes:
The best way is to print this is with both slot pegs having very high infill with top and bottom layers. However this would disrupt the 'hollow' look of the original design since the actual holders would have at least a bottom layer on the printing surface side.
(there are work arounds using S3D to merge the separate pieces each with their own profile).
As a compromise, I set 3 perimeters and allow the lower slot peg to match the 'hollow" infill of the arm, and then use the Variable Settings Wizard in S3D to make the upper slot peg 100% infill with top and bottom layers for strength. Using PETG, this is more than strong enough to hold any reasonable amount of tape.
Supports are needed between the lower slot peg and the upper one.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta