Support me on Ko-fi!

Print Settings:

• Supports not needed
• Lay studs on their sides to print, make sure you have minimal elephant's foot
• 0.2mm layer height works best

Assembly Directions:

Studs slot in on one side only and should be slid to the opposite end. The opening, if printed correctly, should be enough room for the ½" stud and a tool to apply pressure.

Known Issues:

• Missing Magnet Holes

Change Requests:

Please make requests in the comments section. I read them all. I have plans to add more options for the holders including without walls.

• No Wall Version (extend dovetail to end)

Change Log