Which “Verisure” alarm remote control user has not made a mistake with their remote control? the original box having buttons that are too flush with the box, it often happens that when storing the remote control in a bag, for example, a button is pressed by mistake. The status of the alarm can then be changed with all the inconveniences that this may entail.

I have made a small protective box that overcomes this problem.

To do this, I made two small pieces of PETG and used a point cut to the right length to make the hinge. Depending on your availability of points, it may be necessary to readjust the drilling of the parts.

I print the pieces upright with an angle of about 45- 50 degrees. I noticed that it was this position that left the cleanest possible impression. I have voluntarily limited the supports to the maximum.

After a small finish with water sandpaper, the case looks good and you can use your remote control without any worries.