Listed below are some changes that were made.

• Switched to use M3x25mm screws, nuts, and optional washers.
• Moved the Flipper Zero to the bottom of the case and moved the devboard compartment to the top.
• Added Flipper Zero text & logo to the top of the model.
• Created a dual devboard holder.
• Enlarged the compartment for storing various other boards.
• Added a shim for the case. Allows for the Flipper to fit without needing a silicone case.
   

Requirements:

• 4x M3x25mm screws (nuts & washers are optional it will vary on your printer's tolerances)
• ¼ inch foam if you want to keep everything snug, although it is not required.

This model was a remix of:

• [https://www.printables.com/model/259524-flipper-zero-and-devboard-storage-case](https://www.printables.com/model/259524-flipper-zero-and-devboard-storage-case) 
• [https://www.printables.com/model/204882-flipper-zero-case](https://www.printables.com/model/204882-flipper-zero-case)  
• [https://www.printables.com/model/39729-tool-box-parametric](https://www.printables.com/model/39729-tool-box-parametric) 

Revisions

• V1_1 (Updated hinge file to fit the screws)
• V1_2 (Added a shim to allow for the Flipper to fit if you don't have a silicone case)

Credits

Lily _@_v for the redesign 

@Zardoz for file organization & presliced .3mf files.

@zR_CrackiiN for creating the spacing shim file.