Diffuser for Convoy S21A flashlight

Remix of this ([https://www.thingiverse.com/thing:2957181](https://www.thingiverse.com/thing:2957181)) Diffuser for Convoy S series (high resolution version), so it can fit on my Convoy S21A.

I recommend reading Summary of the original project.

I don't think it's needed, but I used some type of raft for better adhesion.

I also recommend .12 layer height because of problems caused by internal overhangs on .20 layer height.

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Supports:

Resolution:

.10-.20

Infill:

Filament: Plast-Spaw PLA White

Notes:

I set thickness to 2 lines (for good light transmittance) but as the author said in the original part comments section, you can experiment with that.

Category: Tools