My first attempt at using FreeCad to build a model from scratch. 

An interface between the table top and the legs for a small DIY side table. 

The legs that I found locally were 45x45mm square at the top, the model has the dimensions set to 46x46mm to account for minor inconsistencies in the leg dimensions. 

The Glass top is 6mm Thickness x 12 Inches Diameter, The top will be glued down using 3M Double sided tape and Silicon Glue. 

Printed at 0.4mm with a 0.2 mm layer height and 30% zigzag infill ( Cura )