Simple razor holder I created for using in our shower. Should fit most of the available razors/shavers. It's not the prettiest but it's useful :)

Short version available here: [https://www.prusaprinters.org/prints/53548-simple-razor-holder-short-version](https://www.prusaprinters.org/prints/53548-simple-razor-holder-short-version)

Print instructions

Even though not recommended, I printed it with PLA. Let's see how long it's going to last.

Measurements:
Overall height: 70.00mm
Overall width: 52.00mm
Space between the two back plates: 3.25mm
Space between the two hooks: 32.00mm
Depth of the hooks (from back plate to inside hook): 12.00mm

It should fit any "standard" sized razor/shaver like the Gilette you can see on one of the pictures.