If you’d like to say thank you, you can always buy me a coffee:
buymeacoffee.com/the4n8 

German:

Gedruckt habe ich die Halterung mit meinem Voron 0.2 mit weißem PLA. Es werden keine Stützstrukturen/Supports benötigt.

Du brauchst meine Mounts, die du hier findest: [https://www.printables.com/de/model/515332-ikea-skadis-screw-mount](https://www.printables.com/de/model/515332-ikea-skadis-screw-mount)
 

Außerdem brauchst du M3 Schrauben (ich habe M3x15 verwendet) und Muttern.

IKEA Skadis: 
- [https://amzn.to/3r9GhEa](https://amzn.to/3r9GhEa) *

Benötigte Schrauben und Muttern (M3): 
- [https://amzn.to/445gOuk](https://amzn.to/445gOuk) *

Scherenset:
- [https://amzn.to/3PH0mMq](https://amzn.to/3PH0mMq) *

Mein Drucker und Filament:
- Anycubic Vyper: [https://amzn.to/3EbTq3e](https://amzn.to/3EbTq3e) *
- Polymaker PLA weiß: [https://amzn.to/44jDqaa](https://amzn.to/44jDqaa) *

English:

The brackets were printed on my Voron 0.2 in PLA white. No supports needed.
I used m3 (m3x15) screws and nuts.

IKEA Skadis: 
- [https://amzn.to/3r9GhEa](https://amzn.to/3r9GhEa) *

You will need M3 screws and nuts: 
- [https://amzn.to/445gOuk](https://amzn.to/445gOuk) *

Scissors set:
- [https://amzn.to/3PH0mMq](https://amzn.to/3PH0mMq) *

My printer and filament:
- Anycubic Vyper: [https://amzn.to/3KhZFXc](https://amzn.to/3KhZFXc) *
- Polymaker PLA white: [https://amzn.to/44jDqaa](https://amzn.to/44jDqaa) *


 
--------------------------
*Amazon Affiliate Link, advertising, Werbung