Zipper Pull - Doraemon Collar Bell — STL Grátis

Items you need:

2 x “4mm x 30cm” paracord.
4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).
Super glue (for components and magnets).

Suggested print settings:

Layer height 0.2mm (Bell).
Layer height 0.15mm (Black Piece).
Infill 30%.
Position the print in a way that the joining face is facing downwards.
*UPDATE* Supports are recommended at the overhangs where the black part goes (refer to the image or attached 3mf file for more details). Or for ease of setup, choose “Smart Fill” and enable “On overhangs only".
Add a brim to the black piece for better adhesion and to minimise possible warping due to the small contact area.
- Brim Width: 2mm.
- Brim Separation Gap: 0.2mm.

Assembly

Affix the Black Piece to the main body using adhesive.

For more interesting zipper pull charms, be sure to track this tag (Zipperrific).

We've even conjured up a little home for our zipper pulls – because they deserve a stylish rest when they're not out and about with you! And to top it off, each zipper pull features a sneaky slit perfect for showcasing photos, name cards, and more. They're not just zipper pulls; they're your new tiny, table-top pals! 🌟

NOTE
Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.

Descrição

Assembly

Zipper Pull - Doraemon Collar Bell