My first Fusion360 project. I decided to make a pencil sharpener after I was inspired by: [https://www.printables.com/model/227434-hexagonal-pencil-sharpener](https://www.printables.com/model/227434-hexagonal-pencil-sharpener)

Please let me know your feedback. 

Printing Requirements: 

Pencil Sharpener - Cap v8

• Print facing down
• Support from build plate
• Brim recommended for smooth round edges

Pencil Sharpener -Base v5

• No Supports needed
• Brim recommended for smooth round edges

Staedtler 510 Blade

• Required
• Available at Amazon
• To insert into cap place short end into cap holder first then push down at the front where the pencil insert hole.
• To remove blade insert pencil eraser side into bottom of the holder hole and push up.