This model is meant to replace the lid of a standard screw mason jar. There are two sizes for the infuser: large and small. They screw into the lid directly. Please leave a like if you found this model helpful :D

Print Settings: I use a Flashforge Adventurer 3 pro

You can pretty much use the same settings for all parts in this model.
 

• Print Speed: 40-50mm/s
• Layer Height: 0.12-0.16mm
• Shell count: 2
• No supports, no raft
• Brim suggested
• If you find that the parts are too loose, increase your extrusion ratio by 10%