Designed in Fusion360 and printed in 3D Fuel Pro PLA on my MK3S.

Stuff it will hold include, but not limited to:
Candy
Kosher salt
Hardware
The ashes of a beloved deceased pet
A smaller box
Jewelry
Change
Herbs

The model consists of 6 printed parts, I usually do the base, inner, lid and knob in one color then the trim and shroud in another color.

In addition to the printed parts, you will need:
5x M4x8mm Socket Head Cap Screws to attach the inner to the base and the lid to the knob.

Print instructions

I usually print these in 3D Fuel Pro PLA.
15% infill is fine.
.15mm layer height is a great "Goldilocks" resolution.
No support necessary, although the lid could use a little in the recessed bolt hole.
I design in Imperial (Majestic) Units. If you aren't using the latest PrusaSlicer, you will probably have to adjust scale to 2540% because 25.4mm is equal to 1".