set parameters in scad and export all parts.

print:

1x ring lay flat, no support

1x handle vertically on tripod end, no support

2x couplers lay flat. should look like a bridge on one end. supports needed for tongue and slot

slide led strip into ring

solder wires

feed wires through handle and solder a connector

put a coupler on each side of ring where the wires come out

put handle end over couplers, pin in place via scrap filament.

thread lib from:

[https://www.thingiverse.com/thing:2030942/files](https://www.thingiverse.com/thing:2030942/files)