This plant pot gadget lifts your pot about 1cm from the ground. Water will run out better and air gets better to the roots. This makes a healthyer plant :) siutable for many plantpot sizes!

• measure across the bottom of the with of your plant pot
• the plant model at 100% is suitable for a bot with a 10cm base.
• scale to make it fit your plantpot. (only adjust x and y)
  zb 50% for a 5cm pot; 120% for a 12cm pot; 85% for a 8,5cm pot; usw....

Print instructions

-prints without support, 0.3mm draft is fine enough