HQ Camera case that can be attached directly to telescope focuser via M42x0.75 therad. It was modeled using Fusion360. I have also added XML file with custom thread that actualy prints as it should without any scaling needed. Just rename that fle to XML and add it to the Fusion360.

It also has standard photo thread to attach it to tripod.

To fit your camera in this case, please first remove tripod holder (see picture).

Many thanky to my friend Broz22 from cloudynights forum, who helped me a lot with test 3D prints. Here are his notes:

“The camera housing base printed fine at .07mm/layer in PETG, although, there is some stringing that has to be cleaned up a bit. For the housing cover you should use layer thickness of 0.3 mm. Please do not to print PETG on glass! Garolite works fine. You could probably print these in PLA since they are not likely to be exposed to higher temps"