This, as I said above, is a cool fidget switch with a simple design.

The assembly is pretty basic:

1. Slot the spring in the base
2. Put the switch on the cylinder
3. Put filament in the holes in the base and glue them in if needed (or hammer in if the tolerance hasn't worked)
4. Then slot on the top

This model uses small lengths of filament to press fit together because it is stronger and more space efficient than normal 3d printed pins. All the tolerances are 0.3mm which should work if the filament, for whatever reason, can't fit you can hammer it in or drill the holes bigger.

All slicing settings are standard.

Thank you for using my design :)