Recently I added some recessed deck/pathway lighting and wanted some form of reflector to direct most (if not all of the light) towards the ground, since the lights i obtained did not include this i created the following models.

I also wanted the ability to easily take the housings apart in the fall so I could bring the lights indoors during the winter without having to constantly screw and re screw into the wood.

There are 2 designs here.

The first design is an entire housing split in 2, I used it for mounting on the top of the wood. (ie: walking area of a deck).

The second design is for when the pot light is recessed into a wood board.

Print Settings

Layer Height 0.30mm

Material: PET-G

Infill: 40% or as high as you want :)

Additional Hardware Required

M3  Cap Head Screws

M3 Nuts

Countersunk Deck Screw.

Lights i used have a barrel diameter of approximately 22mm with a flange portion at around 30mm. I have linked the specific ones below i got from amazon below.

[https://www.amazon.com/gp/product/B0827RWX1V/ref=ppx_yo_dt_b_asin_title_o07_s02?ie=UTF8&th=1](https://www.amazon.com/gp/product/B0827RWX1V/ref=ppx_yo_dt_b_asin_title_o07_s02?ie=UTF8&th=1)