This is a container for Jelly beans or small chocolate eggs.
I have designed it from scratch based on the idea from muzz64, [https://www.thingiverse.com/thing:3537163](https://www.thingiverse.com/thing:3537163)

You can open or close the egg by rotating the outer shell in regards to the inner shell.

You can use it as a small Easter gift to a child or grandchild. Do not forget to fill it, after printing, with jelly beans!

The total height is 10 cm.

There are 2 versions with "Happy Easter" and one version without text.
When you want to change the text ("Happy Easter") give me a notice with your email address and I will send you the Fusion 360 file so you can change the text.

Print it carefully, the walls are only 1.2 mm and the separation between the inner and the outer shell is only 1 mm.

Print instructions

Category: Containers Summary

This is a container for Jelly beans or small chocolate eggs.
I have designed it from scratch based on the idea from muzz64, [https://www.thingiverse.com/thing:3537163](https://www.thingiverse.com/thing:3537163)

You can open or close the egg by rotating the outer shell in regards to the inner shell.

You can use it as a small Easter gift to a child or grandchild. Do not forget to fill it, after printing, with jelly beans!

The total height is 10 cm.

There are 2 versions with "Happy Easter" and one version without text.
When you want to change the text ("Happy Easter") give me a notice with your email address and I will send you the Fusion 360 file so you can change the text.

Print it carefully, the walls are only 1.2 mm and the separation between the inner and the outer shell is only 1 mm.

Print Settings

Printer Brand: XYZprinting

Printer: da Vinci 1.0 Pro 3in1

Rafts: No

Supports: No

Resolution: 0.3 mm

Infill: 30%

Filament: REC PLA Beige
Notes:

You can also print it with a smaller layer height.
Supports are not needed.

Post-Printing

After printing you probably have to break loose the inner shell, because of stringing or blobs and zits. For that reason there is a small indent in the bottom where you can rotate the inner shell with a coin.