The .3mf file is already set up correctly to test your printer's flow.

• You must enable brim to hold the pieces together (10 lines should be enouth) and preferably set line width to 0.4mm.
• You should obtain at least one box with the surface fully filled but without an excess of filament.
• If your print is well configured for your filament, you should get the best impression on the 9th box (1.00).
• See the correction factor image to see how much you need to change the flow of your print.

Example: if your best impression is on the 0.70 box, you must correct the flow to 70%.

Instructional video (in Portuguese - turn on subtitles if necessary) [https://www.youtube.com/watch?v=nqgzjwpc9F8](https://www.youtube.com/watch?v=nqgzjwpc9F8)

The original file was taken from Jasmine's GitHub [https://github.com/jasminemoreira/3D_printing/tree/master/Calibration_Matrix](https://github.com/jasminemoreira/3D_printing/tree/master/Calibration_Matrix)

Thanks to Jasmine Moreira! [https://www.thingiverse.com/jasminemoreira/designs](https://www.thingiverse.com/jasminemoreira/designs)

Print Settings

• Rafts: No
• Supports: No
• Resolution: 0.12 or 0.2
• Infill: 0%
• Notes: I sliced this object using Ultimaker Cura

You can help me buy a beer! :)

Any amount would make me happy and extremely grateful.

PayPal: [https://paypal.me/maurymmarques](https://paypal.me/maurymmarques) 

Patreon: [https://patreon.com/maurymmarques](https://patreon.com/maurymmarques)