This is a simple chest that has a pin hinge to open and close so that you can store stuff inside. I am not sure if it is able to be printed at a smaller scale, because the hinge might connect to the outer part. I printed this at 0.20mm SPEED, it took 20 hours and 40 minutes to print, but I think it turned out great. Not counting the space in the lid, the inside of the box is 503 cubic centimeters

---------------------------------------

Supports:

At the bottom of the chest, so the end of the hinge can be printed;

Inside of the chest, so it supports the roof (or the side, because it is printed on its side)

---------------------------------------

Files available:

.stl 

.3mf

.gcode

---------------------------------------

Print time: 

0.15mm QUALITY: 1d3h39m (high detail)

0.15mm SPEED: 1d0h4m (high detail)

0.20mm QUALITY: 23h38m (medium detail)

0.20mm SPEED: 20h41m (recommended, medium detail)