replacement single-piece scroll wheel for the g600. Fits exactly in place of the old one, and keeps the feeling of bumps/clicks when you scroll. As silly as it sounds, I designed this to replace the original plastic/rubber wheel so that my bird couldn't tear up the rubber anymore.

The model has been split into 2 parts to avoid having to use supports, super glue them together and you're good to go.

Print settings I used (all in the .3mf already):

• 10mm brim (IMPORTANT) - I tried several times, this thing will pop right off the bed mid-print if you don't use a brim
• 0.4mm extruder (if you have smaller, I'd recommend using that)
• 0.05mm layer height - going this fine was mainly to get the fillets on the ends of the center rod printed correctly. you could always raise this and sand them round instead
• avoid passing through perimeters - helps save some cleanup in the code wheel slits
• random seam position - again helps save some cleanup time on the center rod
• I used 100% infill, but the infill area is so small anyway it probably doesn't matter

installation is straightforward, it fits exactly the same way as the original wheel. I also added some super lube to the inside surface of the wheel to remove a slight squeaking sound when scrolling one way.