Small Support Table used as PC screen stand
Width 240mm High 172mm Depth 195mm
Almost the full bed surface
Print time : around 20 hours

Print instructions

Category: Household Summary

Small Support Table used as PC screen stand
Width 240mm High 172mm Depth 195mm
Almost the full bed surface
Print time : around 20 hours

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0.2

Infill: 35%

Filament: Prusament PLA Black
Notes:

To avoid warping and heath bed peels off, the following has been applied:

a glue spray (dimafix)
It was very effective for me. It also makes the surface rather shiny as if it was molded, but any existing makes or too much glue applied on the bed surface will be reported into the print !
Bed temp: 1rt layer 70 and after 65 degrees