This is a redesign of @Bignozz's awesome Baby Yoda themed book stand. I redesigned the stand so that the books (or in my case the Blu-rays / Xbox games / DVDs) transfer the weight to the stand itself, so it no longer slides away.

I also adjusted the size and made it a bit smaller than the original. But it can easily scaled up in the slicer if needed. The figure itself has now no more connection to the stand, so the distance to the stand can be adjusted.

Print settings:

For the Baby Yoda:

• Print it standing
• Supports enabled (I used the organic supports from Prusa Slicer 2.6-alpha6, you have to make sure that on the right hand for all fingers the supports are selected )
• Layer height: 0.15mm

For the stand:

• Print it on the side, this will make it stronger when it comes to holding the books
• Layer height: > 0.2mm (I used 0.55mm with a 0.8mm nozzle)
• Infill: 100%