All the other door stops I found were either too big, or would take way too long to print and waste filament.

So when in doubt. FTIJPI

I made sure to put some grip on the bottom so it doesn't just slide across the carpet and can confirm it works great (results may very on carpet type). The end is ticker then your standard door stop (because its meant to sink into the carpet), so if your doors are very low. It might run into issues.

I've not tested on hard floors, but its not designed for them. Feel free to test if you want but other prints might be better for the job

Hope someone finds it useful for their needs and make sure to share your Makes.

Print Settings

Printer:

Geeetech A10

Rafts: 

No

Supports:

No

Resolution: 

0.3

Infill:

45%

Filament:

Any PLA 

Any