I was looking for an interior window mount for the Blink Indoor camera, similar to this one for the Blink Mini, but couldn't see anything available, so decided to design and create my own.  

This has been tested with a 2020 Blink Indoor camera (gen 2 (referred to as gen 3 in US?)), but should also work with Blink Outdoor cameras of the same generation as the dimensions are identical.

This design enables monitoring of the outside of your property with the camera located on the inside. The advantage of this particular design is that because the lens sits next to the window glass, glare is reduced/eliminated.  

Please note, this model is not designed for earlier Blink cameras such as the XT1, XT2 etc. etc. Please see this alternative design/model for the XT/XT2.

Print settings

I printed the parts as follows:

• Material = PLA
• Layer height = 0.2mm
• No supports required
• 15% infill

Instructions

• Clean the window surface with glass cleaner/alcohol 
• Apply double-sided tape to the outside edge of the printed frame