The original Mavic Mini Controller does not fit my new iPhone Pro Max so I designed this very simple print to fix the problem!  It's custom made to suit a phone with a standard Apple silicone cover, but it does work happily with slightly smaller phones such as my wife's iPhone 13.

In use it's a beautiful fit, and feels much better than the original setup.

It comprises one asymmetrical part which allows for the use of the standard Mavic cable on the one side and when reversed has a cutout to match the iPhone camera.

To increase the degree of difficulty, I designed it to print with no supports and to my surprise printed without any problem at all.  However, if you are a bit nervous about that you may wish to re-orient it to suit whatever support system you prefer.

I used a 0.4mm nozzle and standard PrusaSlicer .3mm DRAFT mode to keep the number of layers as few as possible and to keep the infill simple, and a 4mm Brim all round.

Printed in Prusament Lipstic Red, I couldn't be happier with the result!   If you have a Mavic Mini and an Iphone Pro Max with a silicone cover, you need this print!!