It is able to hold eggs ranging from S all the way up to XL. Each part can hold 10 eggs.

I made this with Fusion360 after beeing inspired by reading tfhh's comment on the old version.

This remix makes cycling through your “best use by” dates way easier as it is stackable with itself without using a base part. If you only need 10 eggs, go here and only print the lower part.

Counter point would be, the whole stack might be a bit higher than using the old version.

----------------------------------------------------------------------------------------------------------------

If you want to help me out a bit and see some stuff I made, work in progress, or models before they will be here consider liking and following my Facebook page, thank you very much - it means a lot to me! :)

----------------------------------------------------------------------------------------------------------------

• Print with:
  • PLA
  • 3 wall loops and top / bottom shell layers
  • 15% infill
  • No supports are needed
  • Brim is needed for Egg_Holder_Stackable_PinSet
  • Reduce speed, else nozzle may bump into stands
  • Use a textured PEI plate for a real good look
  • I recommend printing each part in a different colour to not mistake which “best used by” date is which ;)

• Parts:
  • Egg_Holder_Stackable_MainBody
    • ~50g filament
  • Egg_Holder_Stackable_PinSet
    • 1 of 4 Pins set for each MainBody
    • Tolerance is tight on purpose
    • Use glue

• Updates:
  • None so far

----------------------------------------------------------------------------------------------------------------

I'm looking forward to your comments and makes. :)