[https://realbaddad.com/gromit-headphone-hook/](https://realbaddad.com/gromit-headphone-hook/)
My son required a headphone hook and asked for a Wallace and Gromit inspired hook so challenge accepted.

Searching I found Robert Hagstroms model [https://www.thingiverse.com/thing:4586262](https://www.thingiverse.com/thing:4586262)
From this I sliced Gromits head off and and re-angling it to allow for a pair of headphones to sit on without sliding off, I then added two wall hooking points and done.

As you will see from the slicer image I didn't quite get my scaling correct and had to print it at 97% to allow it to fit my print bed.

Visit our blog to see this and other projects we have completed

Rainbow Smash Axe Build -
[https://realbaddad.com/fortnite-rainbow-smash-axe/](https://realbaddad.com/fortnite-rainbow-smash-axe/)

3D Printed Fortnite Axes & Props -
[https://realbaddad.com/3d-printed-fortnight-axes-props/](https://realbaddad.com/3d-printed-fortnight-axes-props/)

3D Printed Movie Props & Figures -
[https://realbaddad.com/3d-printed-movie-props/](https://realbaddad.com/3d-printed-movie-props/)

Iron man helmet -
[https://realbaddad.com/iron-man-helmet/](https://realbaddad.com/iron-man-helmet/)

Thing Watch Stand -
[https://realbaddad.com/thing-watch-stand/](https://realbaddad.com/thing-watch-stand/)

Minecraft Torches -
[https://realbaddad.com/minecraft-torches/](https://realbaddad.com/minecraft-torches/)

Print instructions

Rafts:
No

Supports:
No

Resolution:
0.2

Infill:
15% could use lower

Filament_material:
PLA