This started out as just an attempt to make a 3D version of my “Milk Jug Ring” cat toy, but I didn't think through the design that much and it ended up being a fun stress test for my printer's calibration.  Its one of those where you sit there watching it thinking… “Is it REALLY going to be able to match up that bridge?”.  

Let's be honest, cat toys don't need to be pretty or elegant - they just need to entertain the critter, and its usually a case of the simpler the better, at least with my beasties.

This one is tricky to print, I'm not going to lie - I'm uploading it mainly because I was amazed that my printer was able to pull it off, albeit a little rough.  I'd wager this would probably print far better on a resin printer.

Printed here in PLA+ with standard 0.2 layer height settings… nothing more.