A stack for the mini-sized Schiit components. This does not require any new screws and uses the rubber feet to hold components in place. I've provided files for a 2, 3, & 4-tall stack.

How does it attach?

This model uses the rubber feet to hold everything in place, and 2 of the original screws on the top component only so no need to buy additional hardware (since they are non-metric threaded).

1. Pull out the rubber feet from the back corners
2. Starting with the top component, remove the 2 back screws on the top and screw the mount on. (Some models don't have the top screw, so in that case, the rubber feet should hold it all in place).
3. Press the rubber feet back in. This is kinda tough and may take a bit of wiggling them around, but make sure they are fully seated back in the holes.
4. Continue working your way down the stack until you place all the components.

Which models does this fit?

This was designed and tested with the mini-size components:

• Headphone amps: Magni+, Vali
• DAC: Modi+ / Modi Multibit
• Preamps: Sys, Mani
• EQ: Loki.

I don't have the larger size components (Magnius, Valhalla, Modius, etc…) but it looks like it may work (the relevant dimensions are the height of the components (32mm + 3mm rubber stopper) and the spacing of the rubber feet from the corner, but I'm not sure if these are the same. If you try it on others, leave a comment. If the dimensions are different I'll upload new ones as well.

Printing tips

Print with the side faces (the larger face) down. I printed at 0.2mm with 20% triangle infill with PETG. Should be fine to make from PLA as well.